Executer le programme:Blink

RAPPEL:Si vous êtes nouveaux,regardez l'article tout en bas !

Pour commencer,connectez votre carte Arduino à l'ordinateur et:

Comme programme,mettez:

/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.

Most Arduinos have an on-board LED you can control. On the Uno and
Leonardo, it is attached to digital pin 13. If you're unsure what
pin the on-board LED is connected to on your Arduino model, check
the documentation at http://arduino.cc

This example code is in the public domain.

modified 8 May 2014
by Scott Fitzgerald
*/

// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin 13 as an output.
pinMode(12, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
digitalWrite(12, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(12, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}

CONTENU DU PROGRAMME:

Les deux lignes delay désignent le temps d'allumage et d'éteignage de la LED (Lampe Electro Diode)

1000 millisecondes = 1 seconde

CIRCUIT:

Réalisez ce circuit:

On éspère que ça vous a plu !