Executer le programme:Blink
RAPPEL:Si vous êtes nouveaux,regardez l'article tout en bas !
Pour commencer,connectez votre carte Arduino à l'ordinateur et:
Comme programme,mettez:
/*
Blink
Turns on an LED on for one second, then off for one second, repeatedly.
Most Arduinos have an on-board LED you can control. On the Uno and
Leonardo, it is attached to digital pin 13. If you're unsure what
pin the on-board LED is connected to on your Arduino model, check
the documentation at http://arduino.cc
This example code is in the public domain.
modified 8 May 2014
by Scott Fitzgerald
*/
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin 13 as an output.
pinMode(12, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(12, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(12, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}
CONTENU DU PROGRAMME:
Les deux lignes delay désignent le temps d'allumage et d'éteignage de la LED (Lampe Electro Diode)
1000 millisecondes = 1 seconde
CIRCUIT:
Réalisez ce circuit:
On éspère que ça vous a plu !
